MATERIAL SAFETY DATA SHEET Product Name: PRO-SEAL 60W, Part A SECTION 1: IDENTIFICATION MANUFACTURER: LiquidConcrete, Inc. ADDRESS: P.O Box 16782, Seattle, WA 98116 PHONE: 1 (800) 201-9300 CHEMICAL NAME: Epoxy Resin COMMON NAME: PRO-SEAL 60W, Part A CHEMICAL FAMILY: Modified Liquid Epoxy Resin SECTION 2: HAZARDOUS CHEMICALS H.M.I.S. RATING Health Flammability Reactivity 1 1 0 APPLICABLE EXPOSURE LIMITS CHEMICAL NAME/CAS # Reaction products of Epichlorohydrin and >95 Bisphenol A / 25085-99-8 Alkyl Glycidyl Ether / 2210-79-9 <5 none established none established N/A none established none established N/A % PEL-WISHA/OSHA TLV-ACGIH OTHER SECTION 3: HEALTH HAZARDS EYES: May cause eye irritation. SKIN: Prolonged or repeated exposure may cause skin irritation. May cause skin sensitization. SKIN ABSORPTION: A single prolonged skin exposure is not likely to result in absorption of harmful amount. The dermal LD50 is unknown. INGESTION: Single dose oral LD50 is unknown. Single dose oral toxicity is expected to be low. INHALATION: Vapors are unlikely due to physical properties. Not a problem unless heated to high temperatures. ROUTES OF ENTRY: N/A MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: N/A SECTION 4: FIRST AID EYES: Irrigate immediately with water for at least 15 minutes. SKIN: Wash off in flowing water or shower. Remove contaminated clothing and wash before reuse. Use extra care with shoes. Revision Date: April 30, 2007 Page 1 of 4 Effective Date: April 30, 2007 MATERIAL SAFETY DATA SHEET Product Name: PRO-SEAL 60W, Part A INGESTION: Induce vomiting if large amounts are ingested. INHALATION: Remove to fresh air if effects occur. Consult medical. NOTE TO PHYSICIANS: No specific antidotes. Supportive care. Treatment based on judgement of the physician in response to reactions of the patient. SECTION 5: FIRE AND EXPLOSION DATA FLASH POINT (method used) >200º F (93º C) (Pensky-Martin Closed Cup) FLAMMABILITY LIMITS N/A LEL N/A UEL N/A EXTINGUISHING MEDIA: Foam, CO2, dry chemicals SPECIAL FIRE FIGHTING PROCEDURES: SPECIAL FIRE FIGHTING EQUIPMENT: Wear positive pressure self-contained breathing apparatus during fire fighting. UNUSUAL FIRE AND EXPLOSION HAZARDS: N/A HAZARDOUS DECOMPOSITION PRODUCTS: Under conditions of imperfect combustion and/or pyrolysis various phenolic compounds CO and/or CO2 may be evolved. HAZARDOUS POLYMERIZATION: Will not occur by itself, but masses of more than one pound of product plus an aliphatic amine will cause irreversible polymerization with heat build up. STABILITY (CONDITIONS TO AVOID): Excessive heating over long periods of time degrade resin. Freezing may cause temporary haziness. SECTION 6: ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Soak up in non-reactive absorbent material or scrape up. The residue can be removed with hot, soapy water. Use of methylene chloride, acetone, or aromatic solvents in clean up poses a distinct hazard and therefor should be avoided. SECTION 7: HANDLING AND STORAGE N/A SECTION 8: PERSONAL PROTECTION AND EXPOSURE CONTROLS RESPIRATORY PROTECTION: N/A VENTILATION: LOCAL EXHAUST: Good room ventilation usually adequate for most operations. Revision Date: April 30, 2007 Page 2 of 4 Effective Date: April 30, 2007 MATERIAL SAFETY DATA SHEET Product Name: PRO-SEAL 60W, Part A PROTECTIVE GLOVES: see below EYE PROTECTION: Safety glasses. OTHER PROTECTIVE EQUIPMENT: Clean, body covering clothing. In addition, rubber gloves, boots, aprons, gauntlets, and full face shield depending on the extent and severity of exposure likely. OTHER ENGINEERING CONTROL: N/A WORK PRACTICES: Practice caution and good personal cleanliness to avoid skin and eye contact. Avoid breathing vapors of heated material. HYGIENIC PRACTICES: N/A SECTION 9: TYPICAL PHYSICAL AND CHEMICAL PROPERTIES BOILING POINT N/A SPECIFIC GRAVITY (H20=1)1.12-1.14 PERCENT NONVOLATILE BY VOLUME (100%) EVAPORATION RATE N/A VAPOR PRESSURE (mmHG) N/A VAPOR DENSITY (AIR=1)N/A SOLUBILITY: N/A APPEARANCE AND ODOR: Liquid of low viscosity, color varies with pigment, epoxy odor SECTION 10: STABILITY AND REACTIVITY INCOMPATIBILITIES: Strong oxidizing agents and nitrates. SECTION 11: TOXICOLOGICAL PROPERTIES N/A SECTION 12: ECOLOGICAL INFORMATION N/A SECTION 13: DISPOSAL INFORMATION WASTE DISPOSAL METHOD: Burn in adequate incinerator or bury in approved landfill. SECTION 14: TRANSPORT INFORMATION Revision Date: April 30, 2007 Page 3 of 4 Effective Date: April 30, 2007 MATERIAL SAFETY DATA SHEET Product Name: PRO-SEAL 60W, Part A D.O.T. Shipping Name: Not regulated by D.O.T. SECTION 15: REGULATORY INFORMATION Status on Substance Lists: The concentrations shown in this document are maximum or ceiling levels (expressed in weight %, unless otherwise specified) to be used for regulations. Trade Secrets are indicated by “TS”. FEDERAL EPA COMPREHENSIVE ENVIRONMENTAL RESPONSE, COMPENSATION AND LIABILITY ACT OF 1980 (CERCLA): Requires notification of the National Response Center of release of quantities of Hazardous Substances equal to or greater than the reportable quantities (RQ’s) in 40 CFR 302.4. There are no components present in this product at level which could require reporting under the statute. SUPERFUND AMENDMENTS and REAUTHORIZATION ACT of 1986 (SARA) TITLE III: Sections 301-304 require emergency planning based on Threshold Planning Quantities (TPQ’s) and release reporting based on Reportable Quantities (RQ’s) in 40 CFR 355. There are no components present in this product at level which could require reporting under the statute. Sections 311-312 require products be reviewed and applicable EPA Hazard Definitions be identified and made known. There are no components present in this product at level which could require reporting under the statute. Section 313 requires submission of annual reports of release of toxic chemicals that appear in 40 CFR 372 (for SARA 313). This information must be included in all MSDS’s that are copied and distributed for this material. There are no components present in this product at level which could require reporting under the statute. If you are unsure if you must report more information, call the EPA Emergency Planning and Right-To-Know Hot Line: 800535-0202 or 202-479-2449. TOXIC SUBSTANCES CONTROL ACT (TSCA): The components of this product are contained on the chemical substance inventory list. SECTION 16: OTHER INFORMATION DISCLAIMER: The information contained herein is based on data believed to be accurate. However, no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use thereof. Recipients are advised to confirm in advance of need that the information is current, applicable, and suitable regarding all current regulations. Revision Date: April 30, 2007 Page 4 of 4 Effective Date: April 30, 2007
